X. WAN

DrayTek VDSL2 Setup with Eircom

Products:
Vigor 130
Vigor 166
Vigor 2620Ln
Vigor 2760
Show all

Keywords:
eircom
fttc
isp
vdsl
Show all


This setup guide demonstrates how to configure DrayTek VDSL2 modem and router products for use with the ISP Eircom.

Vigor VDSL2 Routers - Dynamic IP

These instructions will explain how to configure the DrayTek router to connect to the ISP and establish an Internet connection.

The configuration in this guide requires connecting the VDSL2 line to the DrayTek router's WAN1 DSL port and the DSL LED should be continually lit on the router to indicate that it has sync with the line.


1. Access the DrayTek router's web interface via your web browser, which will be accessible on http://192.168.1.1 by default. Enter the username of "admin" and the default password of "admin".


2. Browse to [WAN] > [General Setup], click [WAN1] and set the VLAN Tag insertion (VDSL2) setting to Enable. Set the Tag Value to 10.
The DSL mode can be set to "VDSL2 only" to speed up sync times but this is not required.
Click OK on that page to apply the changes.

2860 VDSL image 1


3. Go to [WAN] > [Internet Access], set the WAN1 mode to MPoA / Static or Dynamic IP and click the Details Page button to proceed:

2860 VDSL image 2


4. Select the Enable radio button at the top of the page to ensure that the MPoA interface is enabled. Under the WAN IP Network Settings, select Obtain an IP address automatically.

Click OK on this page to apply the changes and the router will then prompt to restart. Click OK to restart the router.

2860 VDSL image 3


5. Once the router has restarted, the [Online Status] > [Physical Connection] page will display the VDSL information and connection status.


How do you rate this article?

1 1 1 1 1 1 1 1 1 1