DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
V166 tweaking target snr doesn't work
- smallal
- Topic Author
- Offline
- Junior Member
-
Less
More
- Posts: 22
- Thank you received: 0
07 Jun 2021 13:29 #1
by smallal
V166 tweaking target snr doesn't work was created by smallal
Has anyone managed to tweak their VDSL SNR via the CLI on a V166 as per this article: https://www.draytek.com/support/knowledge-base/4800
It worked on my old Vigor but although the CLI command on the V166 says it's worked successfully it won't sync no matter how small the tweak (even 0.1dB)
It's really annoying as the V166 seems to set a higher S/N figure (8dB rather than 6.2dB on my old Vigor) resulting in a slower connection
It worked on my old Vigor but although the CLI command on the V166 says it's worked successfully it won't sync no matter how small the tweak (even 0.1dB)
It's really annoying as the V166 seems to set a higher S/N figure (8dB rather than 6.2dB on my old Vigor) resulting in a slower connection
Please Log in or Create an account to join the conversation.
- edinburgh
- Offline
- Member
-
Less
More
- Posts: 230
- Thank you received: 0
08 Jun 2021 10:18 #2
by edinburgh
Replied by edinburgh on topic Re: V166 tweaking target snr doesn't work
Doesn't it also depend on whether the DSLAM equipment supports changing SNR?
What message are you getting?
What message are you getting?
Please Log in or Create an account to join the conversation.
- smallal
- Topic Author
- Offline
- Junior Member
-
Less
More
- Posts: 22
- Thank you received: 0
08 Jun 2021 13:17 #3
by smallal
Replied by smallal on topic Re: V166 tweaking target snr doesn't work
As I said my old Vigor worked fine, I was able to tweak the target SNR down from 6.2dB to 4dB and keep a stable connection, so it's not a DSLAM issue.
Once the V166 CLI command is executed I get the same message as on my old unit - that the change has been successfully applied.
At this point it reboots, but it refuses to re-sync to the line, & if I then input an equal but opposite tweak to cancel out the 1st one it still won't sync!
A power cycle is needed (which clears the target SNR setting back to default) to get things back to normal.
Once the V166 CLI command is executed I get the same message as on my old unit - that the change has been successfully applied.
At this point it reboots, but it refuses to re-sync to the line, & if I then input an equal but opposite tweak to cancel out the 1st one it still won't sync!
A power cycle is needed (which clears the target SNR setting back to default) to get things back to normal.
Please Log in or Create an account to join the conversation.
Moderators: Sami
Copyright © 2024 DrayTek