Hi Folks,
I'm trying to set up a 3300V so that the WAN ports allow traffic to be routed back through to the LAN and it doesn't seem to be happening.

Here's the setup:

LAN network is 192.168.59.0/24, LAN IP is set to 192.168.59.1/24

WAN1 connects to a satellite modem with address 192.168.60.1/24 This eventually connects via a series of hops through private networks to a NAT box on to the public internet.

WAN1 IP address is set to 192.168.60.2/24

In the IP routing tab of the LAN setup WAN1 is enabled and the address 192.168.60.2 entered in the IP address box, the subnet mask is set to 255.255.255.0

Access from the LAN to the internet is working fine, I can also ping the private interface of the gateway NAT box.

I cannot, however, ping anything on the 192.168.59.0 network from the satellite modem. Looking at the active NAT sessions table I see sessions open, so it looks like all the traffic out of the 3300 is being NAT'ed rather than just routed.

Can anyone help me achieve proper routing through the WAN ports?

Cheers,
Robin.