DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
2710Vn not switching to PSTN line on power or ADSL failure
- andrewbracewell
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 3
- Thank you received: 0
25 Aug 2009 21:37 #1
by andrewbracewell
2710Vn not switching to PSTN line on power or ADSL failure was created by andrewbracewell
have just purchased the 2710Vn and setup voip (sipgate). All works well but it doesn't switch the phone line to the PSTN line when either the ADSL line is down or mains power loss. It does say that it should do this in the manual. Anybody else have the same problem. Firmware is 3.2.3.1
Thanks
Thanks
Please Log in or Create an account to join the conversation.
- macavity
- Offline
- Member
-
Less
More
- Posts: 225
- Thank you received: 0
26 Aug 2009 10:56 #2
by macavity
Replied by macavity on topic 2710Vn not switching to PSTN line on power or ADSL failure
What phone port are you connecting to ? I believe it's port 2 that does failover.
Please Log in or Create an account to join the conversation.
- andrewbracewell
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 3
- Thank you received: 0
26 Aug 2009 10:59 #3
by andrewbracewell
Replied by andrewbracewell on topic 2710Vn not switching to PSTN line on power or ADSL failure
Thanks
I have also had a reply from Draytek support confirming that its port 2 is the failsafe port. Its a shame they didn't say that in the manual.
I have also had a reply from Draytek support confirming that its port 2 is the failsafe port. Its a shame they didn't say that in the manual.
Please Log in or Create an account to join the conversation.
Moderators: Sami
Copyright © 2024 DrayTek