DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
2930 Router - Firewall stops
- sam0r
- Topic Author
- Offline
- New Member
Less
More
- Posts: 1
- Thank you received: 0
22 Dec 2009 16:09 #59481
by sam0r
2930 Router - Firewall stops was created by sam0r
I'm using a Draytek 2930 (FW: 3.2.2) to protect my two servers at a hosting centre down in london.
I've configured it using the firewall filter, to forward DNS, Web, SMTP, POP3 etc etc
The error occurs after approximately 10 minutes of uptime, it will just stop filtering all together, no traffic can get in or out with the exception of RDP which mysteriously still works! However, if I make ANY change to the firewall filter (ie. enable or disable a blank rule) it will sping to life again.
In the syslog I'm getting:
"Ethernet destination address doesn't match ARP target adress"
But I can't see anything else that looks out of place.
Any help would be greatly appreciated!
I've configured it using the firewall filter, to forward DNS, Web, SMTP, POP3 etc etc
The error occurs after approximately 10 minutes of uptime, it will just stop filtering all together, no traffic can get in or out with the exception of RDP which mysteriously still works! However, if I make ANY change to the firewall filter (ie. enable or disable a blank rule) it will sping to life again.
In the syslog I'm getting:
"Ethernet destination address doesn't match ARP target adress"
But I can't see anything else that looks out of place.
Any help would be greatly appreciated!
Please Log in or Create an account to join the conversation.
- lozstlouis
- Offline
- Member
Less
More
- Posts: 107
- Thank you received: 0
Moderators: Chris, Sami
Copyright © 2024 DrayTek