Hi,

I'm sure this is obvious to you gurus out there....

I've set up a Vigor 2820 with a Vigor 120 connected to WAN2. All works well but what do I configure to see the connection speed of WAN2?

(I tried setting the IP address of the 120 to within the LAN subnet put could not ping it.)

Many thanks for any assisance suggested.

Thanks Mark

On router main web setup click "online status" there you should see WAN1 and WAN2 ( on the upper right you can switch to other WAN).

Showing traffic as graph click on "Diagnostics" and then "traffic graph". On upper left you can switch the WAN.

Another possibility were if you setup a traffic-application served from the vigor with data via SNMP. For tutorial look here: http://www.draytek.com/.upload/pdffiles/ceb91468d64f0d5e7360ffe029660869.pdf

Merry XMAS!