I have a Vigor120 linked to a Netgear wireless ( Cable) router which has worked fine but can't work out how to access the Vigors Web interface to look at some diagnostics. It doesn't appear as an attached device on the Netgear and the original ip address according to my notes won't work ( 192.168.2.1 ) I have a note about using 192.168.2.1.80 after I'd done the O2 configuration but that doesn't work either.
Can anyone help please

I also need this, so if any knows please help.

I can connect to the web interface of my vigor 2930, but not the seperate vigor 120's.

All I want to do is check the SNR and D/U speeds, as my connections are really bad.

Use a hub between the 120 and your router.

Any other way?

I would like to connect to them remotley

i have tried a vpn to the 2930 but no joy connecting to the 120's

i need the dsl status of one of the modems

If you've got two connections then you can't connect both up this way and it only works with PPPoA connections but you can connect one of the 120s up to a LAN port, give it an IP address in your network's range and connect a cable from your LAN up to the WAN port that the Vigor 120 usually uses.
That'll make it accessible from the LAN so you can check the web interface of it.