I'm having trouble getting a Vigor 2910 and Vigor 110 modem connected to Bethere. The settings I have are:-
Vigor 2910
PPPoE Client Mode Enabled.
Username and password blank.
Mode: Arp Detect
PPP Authentication: Pap or Chap
Fixed IP Address: My BE IP address
MAC Address : BEBox MAC address
Vigor 110 (MPoA settings)
MPoA Enabled
encapsulation - 1483 bridged IP LLC
VPI to 0
VCI to 101
Modulation - multimode
The Vigor 110 is correctly syncing at a decent rate using ADSL2+, however the Vigor 2910 WAN status is disconnected with the message:-
Message [ PPPoE : No response from server side. ]
I used the following guide as the basis for this setup:-
http://www.draytek.co.uk/support/kb_vigor100_setup.html
Any thoughts/suggestions would be most welcome!
David
