DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
Zebedee TCP Tunnel
- chardar
- Topic Author
- Offline
- New Member
Less
More
- Posts: 8
- Thank you received: 0
09 Jun 2010 10:14 #62291
by chardar
Zebedee TCP Tunnel was created by chardar
We use an old bit of open source kit called Zebedee to allow a small office on a different site to access our accounts software. Had it setup no problems with our old Netgear router, but since i installed a Draytek Vigor 2710n i can't get it configured .
It should just be a case of opening the port that Zebedee uses and forwarding it to the ip that runs the software.. but i can't for the life of me get it working!!
Any help would be GREATLY appreciated.
It should just be a case of opening the port that Zebedee uses and forwarding it to the ip that runs the software.. but i can't for the life of me get it working!!
Any help would be GREATLY appreciated.
Please Log in or Create an account to join the conversation.
- chardar
- Topic Author
- Offline
- New Member
Less
More
- Posts: 8
- Thank you received: 0
09 Jun 2010 10:20 #62293
by chardar
Replied by chardar on topic Zebedee TCP Tunnel
Nevermind, the problem is solved....
Not sure why it wasn't working, but suddenly it just started working.
Not sure why it wasn't working, but suddenly it just started working.
Please Log in or Create an account to join the conversation.
- chardar
- Topic Author
- Offline
- New Member
Less
More
- Posts: 8
- Thank you received: 0
10 Jun 2010 08:37 #62301
by chardar
Replied by chardar on topic Zebedee TCP Tunnel
ok so it seems that the tunnel will work once or for a while, but then it won't allow any new connections (existing connection is not stopped). Only way i have found to remedy this is to restart the service on the server. But then we are back to square 1 with one remote user able to connect. This has only started happening since i put the 2710n in but i can't figure out whats causing this!!
any ideas?
any ideas?
Please Log in or Create an account to join the conversation.
- voodle
- Offline
- Big Contributor
Less
More
- Posts: 1139
- Thank you received: 0
10 Jun 2010 09:12 #62303
by voodle
Replied by voodle on topic Zebedee TCP Tunnel
What protocol / port is it using for the tunnel? If it's using UDP, possibly the DoS Defense (under Firewall, DoS Defense) could be blocking it.
If you set up syslog on the router, that'll show whether the router is actively blocking these connections as it will show that in the firewall log tab.
If you set up syslog on the router, that'll show whether the router is actively blocking these connections as it will show that in the firewall log tab.
Please Log in or Create an account to join the conversation.
- chardar
- Topic Author
- Offline
- New Member
Less
More
- Posts: 8
- Thank you received: 0
10 Jun 2010 15:54 #62305
by chardar
Replied by chardar on topic Zebedee TCP Tunnel
Thanks.
It is using TCP protocol, but i will try the syslog.
It is using TCP protocol, but i will try the syslog.
Please Log in or Create an account to join the conversation.
Moderators: Sami
Copyright © 2024 DrayTek