DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2800G, ADSL2+ and SNR

More
12 Aug 2010 09:58 #63293 by flop
2800G, ADSL2+ and SNR was created by flop
My SNR progressively falls during the day. When it reaches 5, the system resets and I synch at a lower speed and higher SNR. Which then falls ... and cycles - fall, reset, lower speed, higher SNR.

Depending on the synch rate when first booted, I will typically run from 09:00 to 17:00 without problem. Then reset and 2hours, then an hour ... until at 22:00 it is 5minutes.

Is the fall in SNR excessive? Is it the 2800G? Is it BT?

System: 2800G [2.7_E38.2.23]; 2.4km from exchange; Atten:37.0 steady; ISP Plusnet.
Typical startup SNR of 12 at 6Mbps downspeed.

Flop

Note. I cannot set the router to ADSLmax or ADSL2+, it stays on G.DMT irrespective.

Please Log in or Create an account to join the conversation.

More
16 Aug 2010 19:33 #63375 by rct
Replied by rct on topic 2800G, ADSL2+ and SNR
try using the recommended firmware for ADSL2+ in the UK from here:
http://www.support.draytek.co.uk/download/v2800_282_e67361.zip

Please Log in or Create an account to join the conversation.

More
17 Aug 2010 13:19 #63383 by flop
Replied by flop on topic 2800G, ADSL2+ and SNR
Is this a suggestion or a guarantee?

I have been wary of upgrading because:-

a) I am a novice
b) I do not have a Plan B if it goes wrong - no backup router.
c) there have been suggestions that 2.8.2 does not result in any improvements....

"I tried 2.8.2 firmware but beta notes said the only improv was wlan for macbook? "
http://www.forum.draytek.co.uk/viewtopic.php?t=14023&highlight=
......
"i tried 2.8.2.1 yesterday with my 2800 on ADSL2+

still got many dropouts per day. "

http://www.forum.draytek.co.uk/viewtopic.php?p=63069&highlight=#63069

Flop

Please Log in or Create an account to join the conversation.

More
17 Aug 2010 15:23 #63386 by howard simpson
Replied by howard simpson on topic 2800G, ADSL2+ and SNR
Have a look at my post for suggestions
nhttp://www.forum.draytek.co.uk/viewforum.php?f=12

Howard

Please Log in or Create an account to join the conversation.

Moderators: Sami