DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

wan1-public ips wan2 natd traffic how ?

  • kbates@wn1-it.com
  • Topic Author
  • Offline
  • New Member
  • New Member
More
08 Jun 2011 10:39 #68139 by kbates@wn1-it.com
wan1-public ips wan2 natd traffic how ? was created by kbates@wn1-it.com
I have a 2820 with wan1 and wan2 connected. Wan1 has a range of routed ip addresses which are setup on the 2nd lan ip address range so they are routed from the internal side. What I want to achieve is all public ip traffic to go via wan1 and all nat'd private ip address traffic to go via wan2.

If I have both wan1 and wan2 enabled some of the fixed ip traffic goes out via wan2 causing problems as i think it might get nat'd not sure. But if a disable wan2 then everything works.

So I set two load-balance policies
1) source fixed ip address range goto wan1
2) source private ip address range goto wan2

If i do a traceroute from a machine with a fixed public ip it goes via wan2 - i can tell as each line has a different gateway

I've tried setting 'ip route default wan1' but it made no difference.

I'm current on firmware 3.3.5.1

Any ideas would be great.

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami