I have an installation of a Vigor2860Vn+ and recently introduced 3 AP-900's.

I decided to use the "Central AP Management" option inside the router interface and sucessfully registreted all the access points.

I then created a WLAN Profile for each access point and sucessfully pushed it out.

The problem is that if the router is restarted the AP's will loose all settings and revert back to default mode using channel 11/36 for 2.4/5GHz



Should I manually configure every Access Point or just not bother and leave all on the same channel???

My idea was to use:

AP1 1(2.4Ghz) - 36(5Ghz)
AP2 6(2.4Ghz) - 40(5Ghz)
AP3 11(2.4Ghz) - 44(5Ghz)




Note: All devices are up to date with Firmware

Anyone ?

Can you screen shot the Default profile on here please? (just the 1st page)

And just out of interest why have you got a separate profile for each AP if there are all the same ESSID?