I've just upgrade my vigor 2830n to 3.6.8.4 and now when I activate the bandwidth limit function, all my IP addresses are limited to 1kpbs upload and download.

I set just one IP address to have 300kpbs both upload and download and the default setting to 0 to allow unrestricted bandwidth to the rest of my IP's but all my devices are limited to 1kbps.

Any ideas?

This feature worked fine before firmware upgrade.

It has been a few years since upgrading the firmware.

Thanks
Trevor

It's possible that the addition of the Kbps/Mbps switch in the Bandwidth Limit section has caused this - make sure that the Default TX Limit and Default RX Limits are set to Kbps.
Try changing the values and modifying the entries in the Limitation List to see if that helps.

Thanks for the info.

I have checked and both are set at Kbps.

There is nothing in my list now, so I just enabled bandwidth and set both upload and download to 0 Kbps and now everything in my data flow monitor has a limit of 1 Kbps in both directions.