Hi

I'm trying to follow this guide on setting up address mapping on a 2830n. I want one internal server to send traffic out using a dedicated external IP, with the rest of the devices sending out on the primary. Easy peasy.

https://www.draytek.co.uk/archive/kb/kb_setup_address_mapping.html

The guide says it supports 2830 and says go to NAT > Address mapping. However on my 2830n I don't see an Address Mapping option under NAS at all, nor can I see it obviously anywhere else. My firmware is 3.6.8.4_sb_232201

Anyone know where I should be looking?

Olly

Sadly, the archive hasn't been updated to reflect the current state of firmware on the Vigor 2830 series (because it's an archive).

This is the method you need to use if the NAT > Address Mapping section isn't there; it's now configured through Policy Routes:
http://www.draytek.co.uk/support/guides/kb-policy-routing-guide

Is there a way to access that document without needing the serial number of the device? Or is there a way to get the device remotely?

Olly