Hi all,

We have a vigor 2820Vn with a dual wan setup (one is an ADSL connection and the other a VDSL modem connected via the WAN2 port).

I would like to configure the vigor to direct specific devices to each wan connection.
I understand it is possible to do this via routing policy, so that specific IP addresses always go via a set connection.

What I'm wondering though is if it is possible to do one of the following:

1) Link a specific LAN port to a WAN connection so that any device connected to it, will be routed that way.
2) as an alternative to the above, create two LAN subsets, assign them to different VLANs and route each subnet to a different WAN connection.

Does anyone know if something like this is possible with the 2820? I understand later models can do this, but I'm not sure about this one.

Thanks in advance for any advice!