Hi.

My VigorNIC 132 doesn't assign IP, so i can't enter web admin panel at http://192.168.1.1

It is set up to use DHCP, but it doesn't work. Manual say that interface should get 192.168.1.1, but it does not get any IPv4 address.

It does not work on any system - Windows 10, Ubuntu oraz MacOS.

I did a reset (by holding reset button for 5 sec. and releasing it on fast diode blinking) - didn't help.

The ATC diode is blinking in 1 sec intervals.

Here are configuration screenshots from Windows 10:

The VigorNIC 132 sold in the UK should be accessible on 192.168.2.1 and it should by default give out an IP address through DHCP.

The ACT light blinking once per second indicates that it should be working normally.

On your PC/device set a static of 192.168.2.10 with a subnet mask of 255.255.255.0 and the gateway: 192.168.2.1 then try again.