I currently have an ER110 Sky modem that I want to replace with a Vigor 130 that bridges to my PFSense on a Dell Optiplex 7010.

I've configured the Vigor 130 to use bridge mode using this guide: https://www.draytek.co.uk/support/guides/kb-vigor-130-bridge

And I've setup PFSense using the instruction in coipu's post at: http://www.skyuser.co.uk/forum/sky-broadband-fibre-help/62156-skyfibre-vigor-130-pfsense.html

But no matter what I try I'm unable to connect to the internet with the 130 and it's driving me mad. Is anyone able to help me get it up and running please?

I've had this configured in the past, so it used to work..... have switched over to VF now though.

Did you get this all working in the end GRiiM?

I've got internet connectivity going ok with what I assume are the correct WAN settings - I just haven't managed to sort out access/routing to the modem status page.

gatesy wrote: Did you get this all working in the end GRiiM?

I've got internet connectivity going ok with what I assume are the correct WAN settings - I just haven't managed to sort out access/routing to the modem status page.

You need to assign the Vigor 130 and the interface on your router with IP addresses from a different subnet to your main LAN and set a statict route on the Vigor 130, the following is not for PFSense but the priniciples are the same:

https://community.ubnt.com/t5/EdgeRouter/Maintaining-access-to-the-DrayTek-Vigor-130-web-interface-when/td-p/1674697

I've managed to get access to the modem via 192.168.2.1 by using a virtual ip on my wan interface and then a NAT outbound rule.
Hopefully these pics will help anyone who is in a similar position where everything was working except for the modem webpage access.
Note I am using VLANS but this should work with a 192.168.1.0/24 address too.