Hi, I have tried searching the forum before posting this but cannot seem to find anything that describes the issue I am having.

I have a Draytek Vigor 130 which is in Bridge mode, I have set the Draytek to 101 for the Vlan but every time I try to configure the Nest it says "Configuring PPPoE failed. Please note that VLAN ID tagging is not supported."

I am at my wits end with this. Any help would be appreciated.

https://www.draytek.co.uk/support/guides/kb-vigor-130-bridge

The only actions required are shown on the above linked page.

Nothing else needs changing. Where have you entered "101" as a Vlan tag?

Hi Adrian - I am not sure how to add screenshots of my settings but in internet access, general setup there is an option for VDSL2 to put in a Tag Value. In the service column I entered 101 as I had read this was the VLAN Tag required by BT ?

You should not enter anything in the "Service" column. If you follow the DrayTek instructions it should work.

Thanks Adrian, I did a factory reset on the Vigor 130 and then followed those instructions and its working now