I'm trying to setup a Vigor 2925 on vlan1 P2 default 10.10.1.1 to a cisco switch on 10.10.1.2.
No trunking, just the one vlan.
My intention is to do the layer 3 management from the switch as I have finer control over access groups.
On the switch I have three vlans setup. The default vlan 1 as above on 10.10.1.2.
Vlan 10 is on an switch vertual interface(SVI) on ip default gateway 10.10.10.1.
Vlan 20 is on an switch vertual interface(SVI) on ip default gateway 10.10.20.1.

I'm trying to set the routing on the vigor to the switch. Trying to set a static route. Been told I need to use a wildcard mask.
So trying to set the equivalant of the cisco ios notation.
ip route 10.10.10.0 0.0.0.255 10.10.1.2
ip route 10.10.20.0 0.0.0.255 10.10.1.2

In the vigor routing page, the mask settings are presented in a drop drop down list, and all are not wildcards but start with 255....
I would be most grateful for any help or pointers to get this to work.

Thank you in anticipation. Nigel.

You appear to have sub-netted the Class A 10.0.0.0 network down into Class C networks, so you want the entry that says 255.255.255.0/24

(the 255.255.255.0 and the /24 are two ways of saying the same thing. Cisco came up with a third way )

I'm not entirely sure what a 'wildcard' might refer to. See if this page helps: https://docs.microsoft.com/en-us/troubleshoot/windows-client/networking/tcpip-addressing-and-subnetting