I need to use the AP central Management feature on a newly purchased 2865ac.
The "wizard" to set up the WLAN Profiles seems to fail at page 2.
The first page of the wizard is OK, but on clicking NEXT to go on to page 2, which it the 2.4GHz SSIDs setup, the first tab (SSID1) does not load properly, when SSID2 is clicked on, the page loads correctly and SSID then be clicked back on to load it correctly.
The next issue is that the NEXT to proceed to what should be the 5GHz SSID setup does nothing, so the wizard cannot proceed and it is therefore not possible to configure a WLAN profile, and therefore not possible to manage the 6 912C APs I need to configure / manage at this site.
All this worked correctly on the 2860 and the 2862 so I would probably assume that this is a specific issue with the firmware on the 2865.
