I have a 2765 and am trying to connect up 2 lines VDSL in Wan1 and using a Vigor 130 VDSL in Wan2. Previously on the 2762 i could have both Wan's as Always on. Now it will only allow Wan1 always on and Wan 2 as Failover. Any one have any ideas on how to have Both always on. I need to have Data down Wan1 and VoIP down Wan2. Rather then changing the router again wondering if any one had the same problem and found a way round it.

Are you sure you're not mixing up the router models?

The Vigor 27xx series only supports 1 active WAN. It's always been that way since the Vigor 2700 with its USB 3G modem capability, then the 2760 with its Ethernet WAN. Each one can use the extra WAN interfaces for failover only.

You need a Vigor 28xx router if you want 2 connections active at the same time for load balancing / policy-based routing.