On my Vigor2865 within Diagnostics >> High Availability Status I only see one row which is R1, I don’t see my second Vigor2865 which is R2.

R1:
LAN5
Management IP: 192.168.3.2
Gateway: 192.168.3.1
Virtual IP: 192.168.3.1

R2:
LAN5
Management IP: 192.168.3.3
Gateway: 192.168.3.1
Virtual IP: 192.168.3.1

Both have VLAN 5 enabled with P5 ticked; subnet set to LAN 5; VID set to 5.
WAN into a switch. Two cables from the switch into R1 WAN2 and R2 WAN2.
Ethernet cable going from R1 P5 to R2 P5.


High Availability set to Hot-Stanby on both routers.
Both R1 and R2 are in group ID 1.
R1 has priority 30 and R2 has 20.
Management Interface set to LAN5.
Authentication Key set teh same.

Nevermind this was fixed by setting R1 and R2 gateways to match the management IP address.