I am trying to set up my 2830n to send all traffic to a VPN service.

I have set it all up and the connection to the service and is seen as valid by the router in Connection Management but I cannot send any traffic to it.

The profile is enabled, set to always on, and the dial out is set to Wan 1 Only.

I want all trafic to use it so am looking to set the 'Change default route to this VPN tunnel ( Only single WAN supports this )' checkbox to true but it is always disabled. RIP direction is disabled. Makes no difference to use Route or NAT.

What can I do to enable it?

Using firmware : 3.3.6.1db_2471201, dated : Jun 1 2011 12:05:53

Any help appreciated

BOb