Hi, I have been trying to configure a Draytek 2850 router, so that I have 2 VLAN's setup and a Lan 2 Lan VPN tunnel setup to only be used for one of them.
I currently tick in VPN setup Change default Route option to get all traffic to go down the VPN.

I have tried to block the other VLAN to use the VPN and go straight out of the WAN port but I can only block it totally or allow through the VPN.
I have tried unticking the Change Default Route option, but then no traffic goes down the VPN and can't seem to route any traffic from 1st VLAN to
use the VPN tunnel.

Can someone tell me what I am doing wrong and if this is possible. I on the latest firmware 3.6.4
Screenshot's would be good.