DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Vigor 2820 with a wireless link (bridge) to Netgear WPN802

  • shabbaranks
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
25 Mar 2011 10:00 #66956 by shabbaranks
Hi All,

Im trying to setup a wireless bridge between a 2820 and a netgear WPN802. The 2820 see's the WPN within a AP List "Scan" and I add the WPN802 to the bridge list. The WDS mode is set to bridge and the MAC address is listed. The security is set to pre shared key WPA2 - everything appears to be setup fine. When a client connects it cant ping or see the 2820 via the wireless bridge :(

Any ideas?

Thanks

Please Log in or Create an account to join the conversation.

More
28 Mar 2011 13:14 #66997 by howard simpson
I found that when using a 2820 in WDS mode you had to power off and power up both ends to get it to work after doing the config.

Howard

Please Log in or Create an account to join the conversation.

  • shabbaranks
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
28 Mar 2011 15:59 #67001 by shabbaranks
Thanks Howard will give it a go... Was this when trying to pair another Draytek AP or a different model?

Please Log in or Create an account to join the conversation.

More
29 Mar 2011 09:13 #67012 by howard simpson
I have had WDS working from a 2820N to a 2600G (just in use as an AP) and also a AP700 which replaced the 2600G to get wireless n. Must admit I eventually bit the bullet and put in a cable between the 2820n and the AP700 as my walls were to thick to get good performance using WDS. 200year old house with stone walls 2-3ft thick!.

Howard

Please Log in or Create an account to join the conversation.

  • shabbaranks
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
29 Mar 2011 09:54 #67013 by shabbaranks
Am I missing a trick as its not working... Heres my setup:

Vigor2820 WDS plugged into LAN DHCP relay enabled - NetgearWPN802 (static IP) with PC plugged into it.

As the Netgear is a G and the 2820 is on N I enabled a second SSID to attempt to pair the Netgear with the Vigor2820 both on WEP (as I read this had to be WEP???). As the netgear doesnt have DHCP relay I guess I have to static the client connected to the Netgear which I have - still no joy. I also rebooted both in an attempt to sort this but again it doesnt work.

Any ideas what I am missing?? Thanks

Please Log in or Create an account to join the conversation.

More
30 Mar 2011 10:56 #67024 by howard simpson
Firstly I think that the 2820 should be set up as the DHCP server unless you have an other on the network in which case you will needthe relay function.

Secondly you cannot WDS to a G AP with the 2820 set up with n mode, I tried it and it would not work. It will work if you restrict the 2820 to the other modes.

Howard

Please Log in or Create an account to join the conversation.

Moderators: Sami