Hi,

I have an AP903 as a Mesh Root, with a couple of AP802's.  The AP903 runs two SSID; trzWLAN which connects to my main network, and trzGuest which is a guest network and runs over VLAN10 to separate the networks.  However I want to remove the smart switches on my network and replace them with faster 2.5Gbps unmanaged switches.  Looking at the documentation it seems to suggest I should be able to associate LAN B with an SSID and connect that physically to a port on my firewall to create the separate network.

However I can't find the configuration for LAN B under any of the menus.  All the documentation seems to suggest it should be under LAN > General Setup, but there's nothing there or anywhere else.  I am running firmware 1.4.16.

Am I missing anything?  Is it something with the way my AP is setup (Mesh), or is what I am trying to do not correct?

Many thanks for any help.

Under "Wireless LAN (2.4/5) General Setup" do you not have a box labelled "Enable 2 Subnet" ?

Oh you star!!  I knew it had to be a level of muppetry on my part.  That seems to have worked!  I haven't tested it as yet, but that enabled me to select LAN B, and now given me LAN B under LAN >> General Setup as well.  So much further along than I was previously.

Many thanks for your help, tis much appreciated

Can confirm that all works

There was some faffing about with DHCP relaying, etc., which required a reboot of the AP903 (which took a little while to figure out).. but all works completely as desired.

Many thanks again @piste Basher