tonite i upgraded to the new final 3.3.2 (.rst).. it was unsucessful, i was forced to use the Abnormal Firmware Conditions guide, and i managed to get back onto 3.3.1.2.

so this time before updating firmware, i saved my config & then reset my settings to factory default.
then upgraded to 3.3.2 and it went though ok.

then i imported my old config file, and the router locked up/stopped responding, LAN light went off etc.

so i again went back to 3.3.1.2, manually noted down my firewall filters/qos//mac binds/schedules etc, then did a clean update to 3.3.2 and manually entered all my settings.
took a while, but now working ok.

Did you had the VPN services (VPN and Remote Access >> Remote Access Control Setup) disabled in the old config?

This was the reason for my "brick-experience" Have got then the 3.3.2.1 Firmware from Draytek Support and now I can disable the VPN services without problems.

Cheers

nope vpn enabled