a web interface bug with the ooold firmware

If you update using Internet Explorer specifically then it should work.

The order you've got the LB policy set up in may be causing your problems, swap around rules 1 & 2 because rule 1 is a catch all rule for WAN2, that should be run last to catch remaining connections, at the moment it's taking priority over LB rule 2. Later firmware has a Move Up / Move Down option so you won't need to remake the rules with that.

Thanks for this, I will try it later today after I fix the problem:

Unfortunately, last night I try again to apply the Firmware 3.4
using the DrayTek utility and now the Router stop working at all, it come up and then stuck, no network connection and no lights on any of the connection.
Is there any utility to undo or reset the last apply Firmware?

Ok , I manage to load 3.3.5.1_211801.

Index: 1
Enable
Protocol: any
Binding WAN Interface: WAN1
Src IP Start: 217.x.x.136
Src IP End : 217.x.x.142
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End

Index: 2
Enable
Protocol: any
Binding WAN Interface: WAN2
Src IP Start: 192.168.1.2
Src IP End : 192.168.1.254
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End

Still no joy .. :evil:

The main problem is on the machines that have 2 network card; one with internal IP and the second one with public IP.
On those machines it always go out on the public network IP never on the internal.

On the machines with only one network card (internal) the speen is very slow it never get anywhre near the right speen.

The way I had it before:
Vigor 2910 connect to the Cable DSL
Vigor 2600 connect to the ADSL

All machines gone via switch, and the switch connect to both routers.

Alll working OK and all machines will always go via the Cable DSL, only the machines with Public IP will go (when needed) ob the ADSL.
The speed on the DSL was near 20Gb on the ADSL 2Gb (down).

Now I am not getting more then 5 on the DSL and none of the machines with public IP can go on the Cable DSL they will always go on the ADSL (remember the machines have also internal IP on saperate network card).

Comming back to my first question; I can see that the defualt route on the 2820 id the ADSL IP (WAN1) - is there any way to set it up to be the DSL (WEN2)?

The good one first:
I magane to upload the Firmware Version: 3.3.5.1_211801

For all to know:
If the router stuck, tern the router OFF, press the reset button and tern the router on at the same time, the router is getting into TFTP mode and you can upload the firmware via DrayTek utility.

So all working OK, the only way to get the PCs with 2 network card to go on the DSL is to give the network with the public IP second IP witch is local IP, then all working OK.

Now the Bad news:
I create some Filter on Firewall >> Filter Setup, but every time I restart the router they disappear

I try on both IE and Firefox but always when the router reboot they disappear

Please HELP
Please HELP.

Ok, all working Ok and I found the answer on DrakTek site:
http://draytek.com/user/SupportFAQDetail.php?ID=2034
:lol:

Wow, thanks for spotting that, I had no idea it could be done that way, maybe it's a recent change? I've always used the method they said not to use :oops: