Hi,

Title says it all updated firmware, now cannot access the gui via the usual 192.168.2.1...

Am i missing something?

Also when i connect just the vigor 130 to my laptop via ethernet, and try to find the ip (via cmd) there is nothing under the defaul gateway (its blank)

EDIT: i do have internet conectivity on both LAN and Wireless so i am sure i must be doing something wrong...

What firmware did you use?

An upgrade shouldn't touch the settings .

Did you wait for the firmware to flash and fully restart the modem?


Have you tried a factory reset via the reset button on the rear panel?

I used the firmware labelled v130_374BT

and yes did wait before doing anything, tried to factory reset via the button at the back of the modem, still no joy...

You need to speak to Draytek support then.

I have the same issue, I upgraded to latest Firmware, used the .all file for update , my Vigor was at the time 192.168.1.1 to access it.
on rebooting after update it was there for a second then nothing however i can ping the ip and get a reply , i've done several Hardware reset ( button on the back with pin )

I'm assuming that the new firmware added VLAN tag 101 as default, I can't added 101 to my laptops interface ( wired )

Notes:
DHCP seems disabled on Vigor130 , thou I've tried 192.168.0.1 and 192.168.2.1 by adding static to my laptop for ip and gateway as such , the only one that gives ping back is 192.168.1.1 but no GUI web response

Weird. Maybe it's faulty will return to Amazon...